CS Unitec ETN 2001 P 2-Speed Hand Held Wet or Dry Concrete Core Drill for Holes up to 4″ Diameter

The ETN 2001 P concrete core drill is ideal for hand-held drilling of concrete, reinforced concrete, brick, block and stone
This machine offers wet and dry diamond core drilling with the same tool; replacing the water seal is easy and can be done on the job
STANDAR FEATURES INCLUDE: safety slip clutch, thermal overload switch, water swivel collar, ground fault Interrupter, and metal carrying case

$1,103.00 (as of November 9, 2018, 8:10 pm)

Usually ships in 24 hours

Description

The ETN 2001 P concrete core drill is ideal for hand-held drilling of concrete, reinforced concrete, brick, block and stone. This heavy-duty wet and dry diamond core drill has high torque output. Use hand-held or Rig mounted. Two-speed gearbox provides the optimum RPM for hole sizes as much as 4-inch diameter. Electronic torque limitation and speed regulate guarantee constant RPM even under load. Click at the CS Unitec link at the best of this page to peer more quality products from CS Unitec.
The ETN 2001 P concrete core drill is ideal for hand-held drilling of concrete, reinforced concrete, brick, block and stone
This machine offers wet and dry diamond core drilling with the similar tool; replacing the water seal is simple and can also be done at the job
STANDAR FEATURES INCLUDE: safety slip grab, thermal overload switch, water swivel collar, ground fault Interrupter, and metal carrying case
15 amp, 110 volt, load speeds (rpm) 0-800/ 0-1570, no-load speeds (rpm 1000/ 2300), 52 mm collar diameter, 15Lbs
Made in Germany

Additional information

Brand

Label

Manufacturer

ProductGroup

Reviews

There are no reviews yet.

Be the first to review “CS Unitec ETN 2001 P 2-Speed Hand Held Wet or Dry Concrete Core Drill for Holes up to 4″ Diameter”

Your email address will not be published. Required fields are marked *